pula1

The DS11 Diamond Chain Saw is specifically designed to cut solid concrete underwater. Cuts square corners without over-cut and can plunge cut sea walls up to 18″ thick. Two available bar lengths

(15″ and 18″) and two different chains depending on the amount of rebar and hardness of the concrete. A minimum of 20 PSI water pressure is required at the saw for cooling and lubrication of the bar and chain. Painted hi-visibility yellow.

Features

  • Direct drive motor – no chain coast when trigger is released
  • Integral Stanley Hyrevz gear motor for durability and power
  • Trigger activated water to bar and chain for lubrication
  • Multi position trigger handle and Wall Walker reduces diver fatigue
  • Heavy duty cast aluminum
  • Cut steel reinforced concrete with Pinnacle chain
  • Stainless Steel spool and fasteners
  • Interlocking safety trigger and hand guard
  • Pinnacle Chain: For Steel Reinforced, Heavy Aggregate Concrete
  • Ultra Chain – For Light Wire Mesh, Soft/Green Concrete
  • Order bar and chain separately – See Chart for Selection

Specifications

Capacity 15 or 18″ /
38 or 45 cm Bar
 
Chain Type Diamond Impregnated Chain
Segments
 
Circuit Type Open Center
Flow Range 12 gpm / 45 lpm
Working Pressure 1000-2000 psi / 70-140 bar
Full Relief Setting 2250 psi / 155 bar
Weight 28 lbs / 12.7 kg
(less bar & chain)
 
Length 37 or 40″ / 99 or 101.6 cm
(with bar & chain)
 
Width 9″ / 23 cm
Couplers Yes
Hose Whips Yes (½” NPT Male Thread)
Lubrication/Cooling Internal Water Channels in Bar

pula2